Halogen heater lamp 230V 1000W

Sun, 28 Jun 2026 04:03:51 +0800

On the blow molding floor, preform heating is where the process starts to push back. If the heating tunnel can’t hold the preform’s temperature profile, you’re dealing with inconsistent stretch, unwanted crystallization, or worse—splits. A 230V 1000W halogen heater lamp gives you the power density to correct the thermal behavior without overshooting the preform. What matters under the hood This is a short-wave infrared halogen emitter, built for PET preform heating. The 1000W rating delivers predictable heat flux, and the 230V supply lines up with standard plant power drops, keeping current draw where the heating zone expects it. The quartz envelope and halogen filament respond fast, so the lamp keeps up with line speed changes and varying preform wall thickness without lag. We match the lamp geometry and termination to the OEM heating module, so the thermal coupling and mounting are repeatable. Why it fits stretch blow molding In stretch blow molding, the preform needs controlled, even heating from neck to base. With this lamp, you can dial the heating curve to hit the right temperature window before the blow pin engages, which tightens bottle consistency and cuts scrap. The fast warm-up supports quick changeovers, and the power matches the heating zone design—so you avoid underheating that drags the line down or overheating that bloats energy cost. Field-proven details to keep straight Only install the lamp after checking reflector condition and alignment. A nicked reflector scatters the heat field and throws the preform temperature off. Make sure the socket is clean and rated for 1000W at 230V, and verify lamp orientation—misalignment shifts the hot spot and leads to uneven heating. Quartz is touchy about oils. Handle the envelope with clean gloves to prevent hot spots and premature failure.

1000W on Pro-Grade Infrared Home Comfort

Halogen heater lamp 230V 1000W